AFM 30 
Maximum operating pressures at various temperatures and with various media (indicative values)
Edition: 03/2006, Supersedes all prior editions.
Please see the latest issue at www.reinz.com/datasheet
 
 

Max. operating pressure 1) (bar) at medium

Temperature
(C)
Thickness(mm)Water, steam, aqueous solutions GasesAcids3), alkaline solutions3), amines, acid derivatives Oils, greases Fuels, solvents
-1002)1.0-16-4025
2.0-10-2516
3.0-6-1010
-501.04040106440
2.0252564025
3.0161622516
01.01006425 12564
2.0644016 8040
3.0402510 5025
501.01006425 12564
2.0644016 8040
3.0402510 5025
1001.0644016 8040
2.0402510 5025
3.02516625 16
1501.0252510 6425
2.010166 4016
3.061021610
2001.0-16-25-
2.0-10-16-
3.0- 6-10-
2501.0---10-
2.0---6-
3.0---2-
 
The data quoted above are valid for the material "as delivered" without any additional treatment and with sufficient surface pressure, e.g. according to DIN 28 090ff. In view of the multiplicity of possible gasket designs as well as installation and operating conditions, definitive conclusions cannot be drawn for all applications regarding the behavious in a sealing joint. For this reason, we do not give any warranty for technical data. They do not represent warranted properties. If you have any doubt, please contact us and specify exact operating conditions.
1)Very much higher pressure values are possibly permitted for flanges with projections and recesses or grooves and tongues. Please consult us in individual cases, specifying exact sealing conditions.
2)Use at temperatures below -50 C is possible when surface pressure does not drop below approx. 15 N/mm in liquids or 30 N/mm in gases (internal pressure must be considered). In addition, the gasket must not show bending stress or reversed bending stress. At temperatures below -100 C, operating pressures may not be greater than the max. values given for -100 C.
3)

At temperatures > 50 C, tests under conditions of use must be conducted in the case of strong acids or alkaline solutions, such as hydrochloric acid or potassium hydroxide solution. This material is not resistant to nitric acid > 20 %. In this case, we recommend the use of gaskets made of REINZOFLON 100 (filled PTFE); please refer to Technical Data Sheet TDS 480.

 
 
 
 
 
 VICTOR REINZ 2006